• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

Cutting DTFB with a Dremel?

DankCatnip

Junior Member
#1
Hello!
This is my first post on the FT Forums, so excuse me if I may mess up here and there.

I was wondering, would anybody happen to have any effective DTFB cutting methods using a Dremel?
 

willsonman

Builder Extraordinare
Mentor
#3
I've used a dremel to cut grooves into foam for spars and such. Usually the paper makes a mess but I've not observed any issues other than that.