FunktheEngineer
Junior Member
Good evening Community.
I'm working on a new fpv platform based off of a design I found in an article on FT by dharkless.
http://flitetest.com/articles/one-sheet-no-waste-twin-tail-boom-3-build
It has a 60in wingspan and is designed to house a 2-axis gimbal up underneath the nose for my GoPro. This should give it an unobstructed view forward and down.
I plan on using 3S batteries but haven't settled on a motor/prop/esc combo. I have a few used motors and esc's in my arsenal but I'm just not sure about any of them. Any thoughts would be appreciated. The goal is to have a nice, steady, slow platform.
Below is a picture of the fuselage, wing and tail. I will be using .5" diameter carbon rods for the twin tail booms but haven't mounted those yet.
Thanks for looking and good luck building.
I'm working on a new fpv platform based off of a design I found in an article on FT by dharkless.
http://flitetest.com/articles/one-sheet-no-waste-twin-tail-boom-3-build
It has a 60in wingspan and is designed to house a 2-axis gimbal up underneath the nose for my GoPro. This should give it an unobstructed view forward and down.
I plan on using 3S batteries but haven't settled on a motor/prop/esc combo. I have a few used motors and esc's in my arsenal but I'm just not sure about any of them. Any thoughts would be appreciated. The goal is to have a nice, steady, slow platform.
Below is a picture of the fuselage, wing and tail. I will be using .5" diameter carbon rods for the twin tail booms but haven't mounted those yet.
Thanks for looking and good luck building.