LeeBee71
Member
Being a newbie to this Forum, I'm not sure if I should be even posting in this place. But anyway, my question is about the ideal way in which to set up three stage flaps on my DX6. If I go to the particular aircraft I'm binding to and then go to the Function List, down to Flap System, I can see where I can dial up settings for Pos 0, 1 and 2. I'm using switch D on the transmitter. Now at a different level of access, if I hold the scroller down whilst starting the transmitter, I can go into the settings for the same aircraft and scroll down to Digital Switch Set Up - go to switch D (which is already shown as being allocated to flaps, and it looks like I can put in separate settings to the ones described before in this post. So how do these two different systems relate to each other? I'd also have to say that on the RC plane itself, I can't seem to get enough deflection on the full flaps selection that I would like.
Thanks for any assistance offered, both with the problem I've posted AND how I may have better used this forum.
Thanks for any assistance offered, both with the problem I've posted AND how I may have better used this forum.