AndreasUnzi7
New member
Hello , I’ve been flying quads for almost a year I’ve had 2 bnf’s (Iflight Nazgul, and Arris) this is my first real build. I got it bound to my qx7 and am showing a green light on my xm+. All the soldering seems to be correct as I assume due to that they are plug in (all the soldering I did was for the motors and a bridge on the fc to make it sbus). . In the ports tab I have the correct uart and serial rx. In the config tab I have the correct receiver tabs on (Sbus). I have flashed to the most resent firmware, But when I get to the transmitter tab it shows no stick inputs I have channels put on my controller ready to be used but its showing nothing in beta flight! Thanks for any advise or help its much appreciated!
-Andreas
-Andreas