mwesolowski
New member
I have emax simonk 30A esc and A2212/13T 1000KV MOTORS.
I checked data from receiver and checked data from naze32 (connection do Arduino) and the signal from both devices are correct - naze32 send correct data (until 1978) but motors stop when 1754. My esc cut off motors but I do not understand how to fix it. When I try to calibrate them (esc) no beeps from motors when 2000 (in cleanflight).
It is not because of li-po because my emax simonk 30A spinn from USB only too and motors stop too.
I do not find this issue when motor is spinning directly from receiver.
https://streamable.com/2i16q
I checked data from receiver and checked data from naze32 (connection do Arduino) and the signal from both devices are correct - naze32 send correct data (until 1978) but motors stop when 1754. My esc cut off motors but I do not understand how to fix it. When I try to calibrate them (esc) no beeps from motors when 2000 (in cleanflight).
It is not because of li-po because my emax simonk 30A spinn from USB only too and motors stop too.
I do not find this issue when motor is spinning directly from receiver.
https://streamable.com/2i16q
Last edited: