My first Batbone V-tail build. Flys amazing but i'm still fine tuning it. can't get it to fly perfect just yet.
My setup:
KK2 board
3s 5000mAH Lipo
30 mAh iPeaka ESC
Cobra C-2213/18 Brushless Motor, Kv=1350
9x47 Gemfan up front
8x45 Gemfan in the back
I setup the KK2 just like David did on his bat bone video except I left the stick scaling on KK2 on channel 3 and 4 for throttle at 120. In the video he does a full throttle test and his v-tail tips backwards which is why he sets it down to 100 because of equal sized props on this one.
I'm confused. Lower the stick scaling on throttle on the tail motors will increase the throttle to the rear?
In my case the rear is set to 120... my V-tail on a hover tends to drift forward. I'm all calibrated and zero'd out. Do i have to increase the throttle scaling on this to level it out?
I can use a bit of trim but i don't think this is the solution.
My setup:
KK2 board
3s 5000mAH Lipo
30 mAh iPeaka ESC
Cobra C-2213/18 Brushless Motor, Kv=1350
9x47 Gemfan up front
8x45 Gemfan in the back
I setup the KK2 just like David did on his bat bone video except I left the stick scaling on KK2 on channel 3 and 4 for throttle at 120. In the video he does a full throttle test and his v-tail tips backwards which is why he sets it down to 100 because of equal sized props on this one.
I'm confused. Lower the stick scaling on throttle on the tail motors will increase the throttle to the rear?
In my case the rear is set to 120... my V-tail on a hover tends to drift forward. I'm all calibrated and zero'd out. Do i have to increase the throttle scaling on this to level it out?
I can use a bit of trim but i don't think this is the solution.