BlkSkyQuads
Junior Member
Ok so I finally got my first build up and running. I just cant get the reciever to show in cleanflight. I have tried arming all motors and calibrating all esc's with one shot..... the motors all spin. so that eliminates that. I am using a flysky fs i6s with the fs ia6b and its not responding in clean flight to the naze 32. the LED light is red and solid on the RX and It shows That I have signal on the TX more then half way. But Its not showing in clean flight. what am I doing wrong? 6 Please help
Using Naze 32 rev6 10dof
with neo6 gps
30amp esc all have 5v bec but I only have 5v on one wire/(motor to FC)
2204 2300kv king kong motors
3s 2200mah lipo battery
with Flysky fs i6s transmitter
and fs ia6b receiver.
What Am I Doing Wrong Should I add the 5v to one of the other motor/esc into the FC? PLEASE HELP
Using Naze 32 rev6 10dof
with neo6 gps
30amp esc all have 5v bec but I only have 5v on one wire/(motor to FC)
2204 2300kv king kong motors
3s 2200mah lipo battery
with Flysky fs i6s transmitter
and fs ia6b receiver.
What Am I Doing Wrong Should I add the 5v to one of the other motor/esc into the FC? PLEASE HELP