I have an fpv setup for my 250 quad.
For some reason I can not get an image to display on the receiving end.
Here is a parts list for the setup:
Receiving End
Turnigy Nanotech 3s 1300 mah LiPo
Quanum V2 LCD screen
RC832 5.8 AV Receiver
Circular Polarized 5.8 antennae
Transmitting End:
Turnigy Nanotech 3s 1300 mah LiPo
TS 832 transmitter
Circular Polarized 5.8 antennae
800tvl cmos IR block camera using ntsc powered from 5v to 20v
(from Great Hobbies)
I will post pictures of wiring.
The odd thing is that I have had this setup working in the past. I put it away for storage for a short time. When I brought it out of storage it was no longer working.
I have tried cycling through the channels to no avail.
Maybe there is something obvious I am missing.... not sure.
Any help would be great.
Thanks
For some reason I can not get an image to display on the receiving end.
Here is a parts list for the setup:
Receiving End
Turnigy Nanotech 3s 1300 mah LiPo
Quanum V2 LCD screen
RC832 5.8 AV Receiver
Circular Polarized 5.8 antennae
Transmitting End:
Turnigy Nanotech 3s 1300 mah LiPo
TS 832 transmitter
Circular Polarized 5.8 antennae
800tvl cmos IR block camera using ntsc powered from 5v to 20v
(from Great Hobbies)
I will post pictures of wiring.
The odd thing is that I have had this setup working in the past. I put it away for storage for a short time. When I brought it out of storage it was no longer working.
I have tried cycling through the channels to no avail.
Maybe there is something obvious I am missing.... not sure.
Any help would be great.
Thanks