FT Aura 5

[sly1231]

I have 3 of the FT Aura 5 units. One of these does not show a BLUE led when connected to the FT Aura config tool. It just flashed Blue,Green Orange. I have updated the config tool. What causes this. Is the unit defective. The config tool has been updated.

 

[LitterBug]

Other than the blue light, does it work correctly?

 

[sly1231]

I had it in a plane but now it is on the work bench. Moving it shows correct response on the config tool.

 

[ColoFlyer]

Have you tried to do a full reset of the board. Josh shows you how in this video.

 

[sly1231]

Yes I have - Thanks. It seems to work after the reset. I still do not get the solid blue LED when connecing to the Aura configurator as stated in the vids.

 

[sly1231]

I still have an issue with this unit. It is a plane now and has been set up using the config tool. The Orange & Green LEDs light up indicating all should be good.
I Have 3 flight modes. No Gyro, Level Assist, and 3 D. When I switch from level assist to 3D the elevator and ailerons move - about 2 deg up the on the elevator and about the same on the ailerons.
No deflection when switching from No Gyro to Level assist.
I have been over the setup several times and just don't know what to do.
Any help would be greatly appreciated.