FT Delta Plans

[aviationflyguy]

I just printed off the tiled plans for the Delta and there doesn't seem to have a fin gauge on the plans. Does anyone know where to find it?
Thanks

 

[dwight]

I just did the same, and built the Delta yesterday. In the build video, Josh mentioned that the angle wasn't critical - just as long as both fins were the same. So, I used the foam cut-out from between the inside of the elevons. It worked out great!

Dwight

 

[aviationflyguy]

That's what I was going to do if I couldn't find the answer. Did you also notice there were 16 pages on the site and only 12 to print. I'm thinking the gauge might have been in the other pages in the past...

 

[SP0NZ]

I have the fin gauge in my plans. The angle in ~ 79*. You can get my plans here:

http://forum.flitetest.com/showthread.php?17136-SP0NZ-Plans-Index

 

[grampus192]

It doesn't matter

I just finished mine and I just cut a gauge that looked right. It flew great right out of the box. Just make sure they are the same.