• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

Gremlin board will not arm.

#1
I have just finished completed my gremlin and all the setups. However, when it is connected to my transmitter the light on the board is blinking. Then, when it is armed it blinks twice quickly then pauses and repeats and will not arm.

When it was configured the only issue I had was the BLHeli suite not being able to recognize or flash the firmware to the esc. Although, I was able to flash and configure the esc in the BLheli chrome app configurator. Whenever connected back to the BLHeli suite the firmware is still unknown. Outside this one issue everything worked perfectly.

I'm using the power pack G, DX6 transmitter, and the spektrum quad receiver.