I've got some good news and some bad news, the good news is that I can start work on finalizing the plans. The bad news is that I have to start finalizing the plans...which I find quite boring
To design the wing fillets, I started by glueing the wing from the first prototype onto the fuse that I used to test the opaque canopy, because that fuse has the belly sheeting on it.
Originally I was going to remove the paper from both sides of the foam to make the fillets, but after talking to
@Splinter189 at FF he showed me how to curve foam while keeping paper on the inside of the curve, so I used his method, although I changed it a little bit by removing a lot more foam than what he did when he showed me.
I started by trying to make the fillet that goes on top of the wing one piece, but at this size I couldn't manage it. So I elected to make it out of two pieces. It took me a little bit but I was able to get the first section designed and taped to the plane.
From a top view it looks great,
But I couldn't get the side profile correct. The tip is supposed to be lower on the fuse but I couldn't get it any lower because the foam would have to go from a sharp concave curve to a convex curve, and foam isn't very good at that...
It's close enough for me and still looks good.
Then I moved onto the front piece the two little tabs at the front still have to be glued down.
Here is the little bottom piece, this will have to oversized in the plans and get trimmed by the builder to ensure a tight fit.
There won't be any updates until I start work on the build guide which won't happen until I finalize the plans...