CrawlB4uBall
Junior Member
Hey, I'm having trouble getting this thing off the ground.
I'm first of all let me list what I've completed and can get working. I've calibrated the ESC individually using the receiver, I've uploaded the 2.2 firmware and can get feedback through the GUI with transmitter.
Now, my problem is when I power the board using the battery, the ESCs flip out and start beeping constantly, not the usual set of beeps. I've connected the ESCs to the board through the white signal cable only, except for one BEC on one of the ESCs to power the board until install a UBEC.
Below is a video of what happens. Any info you could give me would be greatly appreciated!
I'm first of all let me list what I've completed and can get working. I've calibrated the ESC individually using the receiver, I've uploaded the 2.2 firmware and can get feedback through the GUI with transmitter.
Now, my problem is when I power the board using the battery, the ESCs flip out and start beeping constantly, not the usual set of beeps. I've connected the ESCs to the board through the white signal cable only, except for one BEC on one of the ESCs to power the board until install a UBEC.
Below is a video of what happens. Any info you could give me would be greatly appreciated!