wraith0078
Member
Well, odd to me at least. I'm hoping someone out there has seen this before.
Electronics on the quad:
Naze32 rev6 Full version.
30A ESCs from Readytoflyquads.com http://www.readytoflyquads.com/f-30a-fire-red-normal-esc-with-rapidesc-fw-for-multirotor
Turnigy Multistar 4225-610KV motors http://www.hobbyking.com/hobbyking/...e_Multi _Rotor_Outrunner.html?strSearch=4225
FrSky D4R-II receiver.
I calibrated my accelerometer and magnetometer, then used the motors section of Clreanflight to calibrate the ESCs. The motors are exhibiting the behavior shown in the video below. It's not always the same one that stops. If I'm trying to run them with the throttle on my radio, they will spin up, then one, sometimes two of them will stop. But if I run them up using the motor sliders in Cleanflight, they work just fine. Also, if I run them singly without the FC in the equation they work fine. I also have a 4-way splitter from a Q-Brain and if I plug them all into that and bypass the FC, they work fine. Naturally, I bought all of this over a year ago, and haven't finished the quad until now. Well, the FC is new.
Any suggestions?
Electronics on the quad:
Naze32 rev6 Full version.
30A ESCs from Readytoflyquads.com http://www.readytoflyquads.com/f-30a-fire-red-normal-esc-with-rapidesc-fw-for-multirotor
Turnigy Multistar 4225-610KV motors http://www.hobbyking.com/hobbyking/...e_Multi _Rotor_Outrunner.html?strSearch=4225
FrSky D4R-II receiver.
I calibrated my accelerometer and magnetometer, then used the motors section of Clreanflight to calibrate the ESCs. The motors are exhibiting the behavior shown in the video below. It's not always the same one that stops. If I'm trying to run them with the throttle on my radio, they will spin up, then one, sometimes two of them will stop. But if I run them up using the motor sliders in Cleanflight, they work just fine. Also, if I run them singly without the FC in the equation they work fine. I also have a 4-way splitter from a Q-Brain and if I plug them all into that and bypass the FC, they work fine. Naturally, I bought all of this over a year ago, and haven't finished the quad until now. Well, the FC is new.
Any suggestions?