Since the last post was received well I'll update yesterday and today.
After I cleaned up wiring for the lights that had very questionable connections and cut and route a corner piece I needed to make a large sheet to cover a wall. I had taken out the pocket door that took up WAY too much room, this is the framing was left.
View attachment 200688
A trial fit shows it was little bit too tall.
View attachment 200689
Once it fit I used construction adhesive and a brad nailer to fix it permanently, hopefully squeak free, to the framing. I think this pic is before I did that.
View attachment 200690
Its not really too much different than building an airplane, measure, cut, fit. Figure out where I measured wrong. Cut again.
I guess I don't have to say that I most likely won't make Flitefest unless there is one later in the fall.
Today's construction is less visible when done, but I built it stout, the toilet mounts on it and I hate a wobbly toilet. The hole in the front is for the heater vent.
View attachment 200698
Then I started cleaning the roof seams. I ordered the stuff to reseal the roof myself and it will save us $$$$.
This whole mess started because the previous owner didn't seal the roof correctly. (Or at all)
Since I don't have time to build planes for my thread I guess this will have to do.