Vortex 150 switch arms GOOD, but should I be able to disarm & rearm without power cyc
So I've made great progress with my Vortex 150. I defined a arm switch on my Spektrum DX6e, which works as expected. However, in the following scenario I wonder if I have the correct expectation:
Power up transmitter
Power up quad
arm motors & take off
Then I do something stupid, which forces me to land (crash). Should I be able to disarm the motors, then rearm & take off????? I've found the only way to get going again is to:
Power down the quad
Power down the transmitter
Then power up & do.
Should I be able to just rearm & go?????
Thanks !
So I've made great progress with my Vortex 150. I defined a arm switch on my Spektrum DX6e, which works as expected. However, in the following scenario I wonder if I have the correct expectation:
Power up transmitter
Power up quad
arm motors & take off
Then I do something stupid, which forces me to land (crash). Should I be able to disarm the motors, then rearm & take off????? I've found the only way to get going again is to:
Power down the quad
Power down the transmitter
Then power up & do.
Should I be able to just rearm & go?????
Thanks !