Wizard x220 with FlySky FS T6 receiver problem

[Fyod]

Today i got my x220. I ordered without the RC because i have the FS T6
When i go to the receiver section in the Betaflight , all my parameters are around 1470 and very unstable - so the 3D model shows that my quad drifting
Any suggestion on how to solve this?

 

[PsyBorg]

Make sure all the radio trims are at center. Go into radio programming and set sub trims so every channel centers at 1500. Then go to "Endpoints" or "Travel adjustment" depending on what term they use and set min channel levels to 1000 and max to 2000. Once that is done NEVER touch the radio trims to change things.

 

[ElectriSean]

You may also have to set the deadband higher to compensate for the fluctuations.