Y6AP, Hexacopter

[w4mps@nc.rr.com]

I'm building the Y6 Hexcacopter (Eric Monroe) https://youtu.be/Z9NJQJv6lw4
I've just finished soldering the ESC and battery cable power connections to the electroplate board. All solder connections look good and I don't see any evidence of solder bridges between + and - . With the ESC's and motors connected I'm getting a low resistance reading when checking for continuity (+ to -). I don't believe there are any shorts. Can anyone advise what I should be seeing when checking with my ohmmeter. I'm sure there is capacitance with the motors and ESCs connected but not sure if there is another problem I should be checking for. Many thanks.
Marc (W4MPS)

 

[FPVology]

You can always plug in using one of those light bulb thingies. the bulb will blow before anything on the copter gets fried.
Check it out HERE.

 

[w4mps@nc.rr.com]

Y6 AP Hexacopter

Thanks. Clever idea.