My poor tricopter has been laying dormant for several months, due to some damage suffered in it's last flight. Mostly just a bullet connected became separated from the wire it was on, and thus was more than a simple replugging of the wires.
Well, I directly soldered it into the connected on the other wire. This was enough to get it back in the air.
It was VERY twitchy. Not surprising, since I don't even remember which switch, and in what position the different settings are on.
I'm looking at doing a complete rebuild of the system. I have a new plate ordered, and it should be here sometime this week. It will allow me to cut back on some of the wire mess that it's suffering from now.
http://www.getfpv.com/pro-tricopter-power-distribution-frame-plate.html
I'm also looking to get some other replacement parts for it. So it might be an all "new" tricopter soon.
Well, I directly soldered it into the connected on the other wire. This was enough to get it back in the air.
It was VERY twitchy. Not surprising, since I don't even remember which switch, and in what position the different settings are on.
I'm looking at doing a complete rebuild of the system. I have a new plate ordered, and it should be here sometime this week. It will allow me to cut back on some of the wire mess that it's suffering from now.
http://www.getfpv.com/pro-tricopter-power-distribution-frame-plate.html
I'm also looking to get some other replacement parts for it. So it might be an all "new" tricopter soon.
