• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

calibration

  1. A

    KK2 board throttle calibration starts programming ESCs instead?!

    Hi, just want to share an issue I'm having, hope somebody knows how to solve it. I was just calibrating my ESCs throttle to get them in sync on a quad powered by a KK2, but instead of the two beeps at full throttle and then one beep at idle, after the usual ''1+4 button, power up, wait for...
  2. D

    Obscure Brand of ESC - Throttle Calibration

    Has anyone had any experience with ESC's like the one in the above photo? I can't find any documentation for them and they don't seem to adhere to the usual throttle calibration process of signalling max throttle, plugging into the battery, then signalling the lowest value. Any help would be...
  3. Snarls

    Naze32 ESCs Will Not Calibrate/ Motors Not Spinning

    Hey guys, I would normally troubleshoot this myself, but I am a little tight on time. I just flashed CF back onto my naze after running dRonin for a little bit. I had to short the boot pins to get it flashed, but it connects to CF configurator now. First I went back to CF 1.09 because I had some...
  4. D

    First Fixed Wing and First Build: FT Tiny Traine electronics.

    So I ordered my Power Pack A tonight. My 3S 800 mah LiPo arrived. The urge hits. I pull a motor and esc from the junk bin. Solder it up. Plug it in (ch 1 just like on the video). Beep beep beep beep won't arm. Then it hits me in the video they always hook up Spektrum or Graupner (motor on...
  5. C

    Drain grid cover tri-copter & INFLIGHT_ACC_CALIBRATION question

    Hi there I'm very happy with this folding tri-copter I've made with a NAZE 32 Funfly board and a grid cover and some old uPVC electrical conduit. It's flying great but I have to manually adjust the roll and pitch angles in CleanFlight or add a lot of trim to counteract the fact that the...
  6. U

    Turnigy 9XR Pro - Rudder control is a bit wonky?

    Let me know if anyone else has seen this. I have a brand-new Turnigy 9XR Pro transmitter. I am new to RC so this is my first "Big boy" transmitter. I have noticed, just playing around with it before I got my module in the mail, that the rudder channel isn't at 0 when the stick is at 0...
  7. Mastrmindz

    My ESCs and Multiwii Stink

    Yo forum! I got a multiwii flip 1.5 back in May. Do not like it that much. I eventually converted my tri to a quad. I got it flying for a little while. One time I tested it, and the thing kept pitching backwards. Could not figure out why after all of the settings I did to it. During that...