connection

So, I recently got myself the FatShark Recon V3 Goggles. They are great and work really good with my Whoop when I fly in close a perimiter. Now I want to change the default linear antenna to a different one I have lying around. The problem is the connector. My question is now If it is possible...

I have an Eachine Falcon 250 Pro with a naze32 and eachine ia6. I also got a qx70 and bound to it with my eachine i6, not realizing i needed a new profile for each model. Instead I made a new model and bound my ia6 to it after realizing that. The ia6 operates exactly the way it should, and it...

Ok, so I got a falcon 250 pro from eachine, and it came with an eachine i6 transmitter. Now I want to connect that to the DRL simulator. I got a dongle (22 in 1, from banggood) and installed an SI driver (silicon labs I think?) and finally got the game to recognize a controller. I think that my...

Hello all, I have been watching videos of you guys on youtube and you guys got me interested in starting playing around with quads. So I watch some more videos until I decided to go ahead and buy myself a quad :) I got a wizard x220 with a naze32 in it. I also got a Flysky 6CH FS-i6 Remote...

i have the Spektrum DX6e controller with a Spektrum Quad Race serial receiver and the controller is binded to the receiver (because the orange light is solid), however the receiver will not relay information to the flight controller which is a naze32 im not sure if they are compatible and i'm...

Out of control - need help on initial setup [solved] hello! im just setting up a new quad, with an F3 and frsky receiver - i could successfully bind, but for some reason im not getting the control inputs in cleanflight the receivers SBUS connection is on CH3 of the flight controller (ofc i...

Hello, so I'v built and flown a couple of time my s500 quadcopter. It weighs 1.5 KG and hovers around half throttle. I have had a frequent problem of it just losing power suddenly, which is due to the turnigy banana connectors not being wide enough with the two banana connectors attached to the...

Hello all, This is my first build, a QAV250. I am using a friend's DX6i in order to save money for the time being. I purchased an OrangeRx r615x to go with it. The naze32 came in the mail today and I have been following along with Flite Test's Naze32 video. I have done the accelerometer...

Pretty simple: my mac simply does not recognize when the ReadytoFlyer 2.8 is plugged in. I'm using APM Planner, which will acknowledge my USB telemetry module, but it doesn't even show that anything is connected when I plug in the ReadToFlyer. I checked using the stock USB Prober application and...

I am just getting into fpv and I have run into a snag. I have major issues with My GPS, I am running Cyclopes OSD 1.5 and a 400mw 1.2 GHZ video system with a low pass filter and the only way I can get any GPS signal is by removing the OSD and GPS from the plane and moving the GPS as far from the...