So I haven’t been able to figure this out on my own or by watching videos, so I figured I’d come to the community who knows a surprising amount of information on 3-D printers. I have an ender five, I did a first print and it came out wonderful but I switched computers for using Cora. All my settings are the same, but it just won’t print. It starts up, but none of the filament is sticking to the build table. I’ve tried temperatures distances speeds qualities, raising the build plate. and yes, I am using adhesion. I’ve tried three different kinds, but the filament just won’t stick no matter what I do. I tried everything I could find or figure out and it’s still not sticking. What do you guys think I should do?
