Good thing I'm not afraid of a soldering iron! A couple hours this morning were spent putting together a wiring loom to keep everything as tidy as possible. The harness is being designed to connect two batteries on the left with two batteries on the right, running them all through the switch panel. So far I've finished and tested the harnesses to power the receivers and next will tackle the rest of the harness for the ignition and light circuit.
It's still a bit rough and unfinished, but I'm happy with how it's turning out. Powering up the plane is done by simply flipping switches from top to bottom in order as needed.
It's still a bit rough and unfinished, but I'm happy with how it's turning out. Powering up the plane is done by simply flipping switches from top to bottom in order as needed.