Sero
Elite member
Problem with X-axis
I created a Bronco G-code and I messed up on sheet 2 as the width was set too wide and the X went off. Fixed that and X axis still went off, this time it wasn't following the G-code. So I swapped out the driver on the CNC shield for a new one and all seemed good until X-stopped working all together and the heat sink was super hot.
I'm assuming I fried my CNC shield? Anybody experience this?
I created a Bronco G-code and I messed up on sheet 2 as the width was set too wide and the X went off. Fixed that and X axis still went off, this time it wasn't following the G-code. So I swapped out the driver on the CNC shield for a new one and all seemed good until X-stopped working all together and the heat sink was super hot.
I'm assuming I fried my CNC shield? Anybody experience this?