DharanFlyer
Active member
Hey guys and gals -
So, looking to add a gimbal to my FPV rail on the Elctrohub at some point in the future. While browsing the HK website I am not 100% sure I know everything I need to succeed in this. I am picking up the Turnigy ActionCam today and was just looking into the gimbal gear I would need. Evidently there is a controller just for the gimbal?
Would anyone mind pointing out the basics of what I would need for a decent gimbal set up? Or an article that I could read through on what I need?
If anyone has any suggestions on some stuff from HK that they are using that would be fantastic! I am not looking to be cheap, but price aware for a decent to good gear for first setup.
Also on the same note, I have a DX6i and from what I can tell I may need to change over my Tx at some point to something with a few more channels with sliders or nobs?
So, looking to add a gimbal to my FPV rail on the Elctrohub at some point in the future. While browsing the HK website I am not 100% sure I know everything I need to succeed in this. I am picking up the Turnigy ActionCam today and was just looking into the gimbal gear I would need. Evidently there is a controller just for the gimbal?
Would anyone mind pointing out the basics of what I would need for a decent gimbal set up? Or an article that I could read through on what I need?
If anyone has any suggestions on some stuff from HK that they are using that would be fantastic! I am not looking to be cheap, but price aware for a decent to good gear for first setup.
Also on the same note, I have a DX6i and from what I can tell I may need to change over my Tx at some point to something with a few more channels with sliders or nobs?