Hello everyone,
I'm getting close to getting my quad together, today I started to get my board ready while I wait for the last of my parts. So I was checking over everything, and found two things I had a question about.
First do I put a header on the pin closest to the rcd label?
I have right angle headers for the rest of them, but didn't notice that when I was cutting the headers.
Also what do those pins do?
My next question is, what is this wire do? I don't remember.
They have a picture of it going into a DSMx Rx.
Thanks for the help
I'm getting close to getting my quad together, today I started to get my board ready while I wait for the last of my parts. So I was checking over everything, and found two things I had a question about.
First do I put a header on the pin closest to the rcd label?
I have right angle headers for the rest of them, but didn't notice that when I was cutting the headers.
Also what do those pins do?
My next question is, what is this wire do? I don't remember.
They have a picture of it going into a DSMx Rx.
Thanks for the help