Hey new to all this.
Just build a size 450 quad with a Naze32 Full board. Did the basic settings using Cleanflight, the quad flies "fine" for now.
I installed a GPS and a Sonar and could not have any of them to work. (No Green indication in Cleanflight)
Anybody can help? Please don't link me to 1 yr old tutorials as I watched/read all of them already and they all use older version of cleanflight which did not do anything to me.
Some details:
Cleanflight v2.0.5
GPS: APM2.5 Ublox GYGPSV1 NEO-M8N
Got it to work with FTDI cable in U-Center, 3D lock and all. No luck in cleanflight... Yes I checked the Rx Tx wiring, even swapped them... Also, every time I reconnect to Cleanflight, the Protocol, Auto Baud & Auto config tabs in Configuration page goes back to default.
Sonar:HC-SR04
Connected to Pin 7&8 with a 1k Ohm resistor, open the Softserial ports, never seen it alive in cleanflight...
Anyone had any of those to work with Cleanflight and know any subtleties to make it happen? I can post a dum if needed, here is some screenshots too.
Anything would help! And if it is not meant to work, please let me know and I will stop wasting my time!
Thanks!
Just build a size 450 quad with a Naze32 Full board. Did the basic settings using Cleanflight, the quad flies "fine" for now.
I installed a GPS and a Sonar and could not have any of them to work. (No Green indication in Cleanflight)
Anybody can help? Please don't link me to 1 yr old tutorials as I watched/read all of them already and they all use older version of cleanflight which did not do anything to me.
Some details:
Cleanflight v2.0.5
GPS: APM2.5 Ublox GYGPSV1 NEO-M8N
Got it to work with FTDI cable in U-Center, 3D lock and all. No luck in cleanflight... Yes I checked the Rx Tx wiring, even swapped them... Also, every time I reconnect to Cleanflight, the Protocol, Auto Baud & Auto config tabs in Configuration page goes back to default.
Sonar:HC-SR04
Connected to Pin 7&8 with a 1k Ohm resistor, open the Softserial ports, never seen it alive in cleanflight...
Anyone had any of those to work with Cleanflight and know any subtleties to make it happen? I can post a dum if needed, here is some screenshots too.
Anything would help! And if it is not meant to work, please let me know and I will stop wasting my time!
Thanks!