Wow, it has been awhile since I have been able to work on this quad. I pulled out my quad this evening and installed the new board, soldered the wiring harness to the receiver, plugged in the receiver to my board, tried it out on Cleanflight, sent the bind command to my copter, and started my transmitter in bind mode.
Still at the same square as before. Still no lights flashing on my lemon-rx satellite receiver. Still no controller input on Cleanflight.
I am 100% positive my wiring is correct, I replaced my FC, could it be my satellite receiver that is bad? I never plugged it into the 5v power so it shouldn't be fried. When I first plug in the quad to Cleanflight via the Micro USB, the lights on the receiver flicker, but do not stay on. No lights on the receiver after initial connection.
Im now back at school so my time to work on the quad is quite limited, but I would still like to get this quad to work at some point. Any ideas or direction for helping me get this quad running would be greatly appreciated.
I did find that this thread was quite useful in configuring my quad for putting it into bind mode.
https://www.propwashed.com/spektrum-receivers-with-betaflight/
Thanks Y'all