Im new to this hobby. Was flying toy drones and then i build few tiny whoops all went well. Then i decided to make a cheap racing drone so that i can lean before going for expensive ones. Issue is drone wobbles left to right ascending and if i use right stick of the transmitter drone flips and fall down.
Here is what i use.
ZMR250 Fame
Emax BlHeli 12A ESC
2204 2300KV Brushless Motors
Naze32 Rev6 10DOF Flight Controller
FlySky i6 transmitter and receiver.
CleanFlight 2.0.3
I didn't do any adjustments in clean flight except adding modes. Using stock settings. Can someone help me out with the issue. Should you need more info i can provide them to you.
CleanFlight PID's
Here is what i use.
ZMR250 Fame
Emax BlHeli 12A ESC
2204 2300KV Brushless Motors
Naze32 Rev6 10DOF Flight Controller
FlySky i6 transmitter and receiver.
CleanFlight 2.0.3
I didn't do any adjustments in clean flight except adding modes. Using stock settings. Can someone help me out with the issue. Should you need more info i can provide them to you.
CleanFlight PID's