• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

FTFC19 Snoopy flying ace designed by Ketchup

Ketchup

4s mini mustang
#3
Before anybody(except for Grifflyer) says anything, I am going to say that I am not going to start this project until my Red Bull air race project is finished. The plane will still be built though, so don’t worry about that.
 

LitterBug

Troll Spammer
#4
I still have the one I designed to be put on a plane or quad last year. :-D Need to paint it and get it in the air still.
 

rockyboy

Skill Collector
Mentor
#8
Yes! :D I've had this on my wishlist for a while, and @LitterBug was thinking about doing it last year, but so far I don't think the forums have produced a set of plans for this yet! Looking forward to this :D
 

LitterBug

Troll Spammer
#9
Yes! :D I've had this on my wishlist for a while, and @LitterBug was thinking about doing it last year, but so far I don't think the forums have produced a set of plans for this yet! Looking forward to this :D
Yeah, not sure where the plans went cuz I posted them somewhere, but they aren't in my thread. I'll dig them back up. Maybe they ended up in the OctoUfo thread...

Ahhh. ACME Snoop Works Hanger
https://forum.flitetest.com/index.p...esigned-by-litterbug.36207/page-2#post-372655
 
Last edited:

Ketchup

4s mini mustang
#10
I know I said that I wouldn’t be working on this project until I finish the one before it but I couldn’t stop myself from at least drawing the plans for a small scale version onto a sheet of foam board. Since I only had a side view of the doghouse, I had to do a bit of thinking before I found out what the most likely dimensions of the house would be. Here are the dimensions: 15” tall (without snoopy on top), 15” wide and well, you guessed it 15” long. It will be powered by a power pack f (the old one with the 2204 motor). It will also have a hidden wing inside the doghouse for extra lift so that it can be flown at a slightly flatter angle instead of a high alpha.
 

Ketchup

4s mini mustang
#11
School started for me so I haven’t had a lot of time to think about this, but I have decided that I will be using a single power pack c motor instead of the power pack f. Also, the plane will be 24 inches wide, tall, and long, not 15. I have also never seen a person put an airfoil into a flying box so there will definitely be some trial and error. (I think that most people have better access to power pack c equivalent electronics, so please correct me if I am wrong.)
 
Last edited:

rockyboy

Skill Collector
Mentor
#12
So we've got plans and build instructions on this one, but has there been flight? I don't seem to see the maiden video around here...