• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

How about a 4 Channel Flying Wing?


Junior Member
Duckerons? Decelerons? Split Elevons? Not sure what they're called.

This is a 48" EPS hot wire cutout thoroughly taped and sparred. I was able to fit two DOW board/XPS elevons on each wing and used 2 low resolution (200 steps, ugh) turnigy v-tail mixers and two mixes in my Aurora 9 (a DX6 would have no problem) to get it to work. It's currently missing winglets and a motor, but I'll probably throw a 35mm on it even though it's already showing signs of being tail heavy.

Here's a control surface test video:

Here's a link to a picture on rcgroups on how to connect it all up - your mixes may vary: