nguyen.tran
Member
I had it hover at eye level indoor before, but not for long.
Just to be sure, for v4.7 when you calibrate, you have throttle stick at 100%, plug in battery, the red led will blink twice then throttle down 0% right?
How do you do stick centering?
This is the video of my maiden flight at full throttle on a 3s and throttle trim is up 80%. Btw in the clip it is me moving the quad around to see if it would improve the throttle or not. The quad itself is pretty stable. I have the 3 pots set at 60%, 50%, 60%. Toward the end, after a turn i tried to throttle up but it couldn't lift itself, so a hard landing is unavoidable!! But thanks to Eric's pool noodle, nothing is broken!
So the story goes like this, i flew it yesterday morning, didnt go very well, last night i tested it again and it hovered at half throttle on a 3s, no trim. Today i brought it out again and now motors dont even start with throttle up. They only start when i have throttle trimmed up at around 70 80%. Weird. Will re-flash.
Just to be sure, for v4.7 when you calibrate, you have throttle stick at 100%, plug in battery, the red led will blink twice then throttle down 0% right?
How do you do stick centering?
This is the video of my maiden flight at full throttle on a 3s and throttle trim is up 80%. Btw in the clip it is me moving the quad around to see if it would improve the throttle or not. The quad itself is pretty stable. I have the 3 pots set at 60%, 50%, 60%. Toward the end, after a turn i tried to throttle up but it couldn't lift itself, so a hard landing is unavoidable!! But thanks to Eric's pool noodle, nothing is broken!
So the story goes like this, i flew it yesterday morning, didnt go very well, last night i tested it again and it hovered at half throttle on a 3s, no trim. Today i brought it out again and now motors dont even start with throttle up. They only start when i have throttle trimmed up at around 70 80%. Weird. Will re-flash.
Last edited: