• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

flight conroller

  1. A

    Reducing hacker motors (X-BL 52S) response time considering the quad-copter controller

    Hi guys, I am trying to implement my flight controller algorithm on a quad-copter using four hacker motors, X-BL 52S. That being said, I have the following questions and I will appreciate if you could answer them: - In my controller the motors response time (the time necessary for a motor to...
  2. D

    Help! Need help please!!!!!!!!

    I have a 6 inch alien frame with a kiss FC and 25 amp kiss ESCs. The issue I have is that I just recently flashed the kiss FC to betaflight, which was a little difficult but I was able to finally get it done but I'm afraid I borked the mcu in the process because now the blue light on the board...
  3. M

    Help! Cc3d Ibus setup, help needed

    Hello everyone, I am having an issue with outdated tech... I want to run a CC3D fc through a 10ch ibus rx (flit10, flysky's protocols) and a modded 10ch fs-i6. Link to rx here: Flit10 2.4G 10CH Micro Telemetry https://banggood.app.link/ragUQcWnUZ I had to download librepilot to be able to...
  4. R

    No blue LED on Flight controller

    I just finished soldering my flight controller and it was find red and blue led was on but today i went to flash the flight controller and then blue light went off. Is that a problem?
  5. A

    Help! Quadcopter receiver to flight controller set up

    Hey, So I'm planning to use a FrSky R9 slim receiver with the mRo pixahawk flight controller. I'm having trouble putting it all together, I'm not planning to use any telemetry radio through it, but connecting the SBUS to it is very confusing. I'm assuming VCC, S.bus out, and ground connect to...
  6. A

    Help! Ómnibus F4 Pro to GPS and FrSky R9mm

    So I’m building a quad, and have gotten a Bn-880 and FrSky R9 mm. I was hoping someone could help connect the R9 mm to my Omnibus F4 Pro. I connected the GPS to UART 3/6 on J10 so that’s gone, and I was planning to connect the Sbus, Ground, and 5V to J7 on the Pinout, but where would I connect...
  7. A

    Help! Flight controller and GPS

    Hello, I am building a quadcopter drone that will at max go around 1.5 miles away from a target. I am planning to use an Omnibus f4 pro and Beitian BN-880 GPS. I am barely starting out so any help would be awesome. I am planning to have an autonomous Waypoint feature to the target. I was...
  8. M

    STSW-STM32102 for Windows 10?

    Through the link provided by most including Clean/Betaflight (https://www.st.com/en/development-tools/stsw-stm32102.html) we are presented with the line "Starting from Windows® 10, the STSW-STM32102 driver is no more adequate and the usage of the native inbox driver is recommended". Well I just...
  9. B

    KK2 order problem

    Hi, I am a 12 year old boy and I am trying to make my first quad copter (SK450). I have already assembled most of the thing. I am using a KK2 flight controller and I am having some trouble figuring out which order to put the ESCs and the receiver on the board. The manual says to put through...