Mr NCT
Site Moderator
My Ender 3 v2 is up and running, currently printing the dog G-code that came on the card. Modifications (so far):
CR touch
Capricorn tube
Flat bed springs
Metal extruder parts
Jyers firmware for Ender and Display
The Y axis was way loose, the bed was flopping around, so I adjusted the wheel tension to get smooth movement without the bed moving up and down or back and forth.
It's all your fault!!
CR touch
Capricorn tube
Flat bed springs
Metal extruder parts
Jyers firmware for Ender and Display
The Y axis was way loose, the bed was flopping around, so I adjusted the wheel tension to get smooth movement without the bed moving up and down or back and forth.
It's all your fault!!