CrusherColin1
Member
I have just got into multi rotors and just built my first kit, the Electrohub. Everything went together fine, but my controller (dx6i and dx5e I tried both) would not do anything (yes i did bind, I'm using a Lemon 6 channel RX). The next thing I noticed was all 4 of my ECS were getting burning hot within seconds so I took the Electrohub apart to look for shorts but nothing on the power distribution board is touching. Does anyone know why this is happening?? Also now when I plug in my 3s 2200Mah battery the Flip 1.5 board doesn't flash blue anymore and the red light doesn't come on. My receiver also doesn't power on when the battery is plugged in now. The only thing I can thing of is that there could be a short in one of my ESC's where I soldered the motor wires to the ESC but would that make all of my ESC's overheat? Please Help, I am 14 years old and very new to multi rotors and building. I have invested pretty much all of my christmas money into this quad so please help. Thank you!
All electronics are from Readytoflyquads with all of the recommended parts
All electronics are from Readytoflyquads with all of the recommended parts