3D printed scratch build
Hi,
I Just thought I'd put up a pic of the micro I've just built. I saw a video for the camera and impulsively bought it for my hubsan X4 but it didn't get off the ground. Then one thing lead to another, research into brushless flight controllers and micro RX and... well here we are.
Spec:
Camera:
MicroFPV.eu (Lefthand circular polarised antena)
FC: multiFlite NANO-B-FC Flight Controller v1.1 (
here)
RX: MicroFRX for use with my Taranis (
here)
Motors: 8.5mm brushed micro motors (
here)
Props: Walkera ladybird (
here)
Frame: custom 3D printed. Yet to upload to Thingiverse
Legs: Cottonbuds!!! (Q-tips??)
Battery: 300mAh 1S lipo (
here)
Note: the battery connector on these is reversed from normal
Removable printed prop guards to help indoor flying in a very small house
AUW: 64.6g with battery (56.2g without)
Flight times: 2:30 (shorter than I hopped for but planning to see how it does with a 600Ah pack at 72.5g AUW)
Hope this is the right place to put this rather than it's own thread.