I recently fixed my flame wheel 550 and decided to go back to start and try to do thing right, like learning to fly in manual mode and just practice hovering.
So here's what I'm running into, in GPS mode I can't the thing off of the ground pretty easy, but I do have a little bit of drift when hovering in GPS mode. But when I switch into manual mode, and give it throttle to lift off, it just flips over. I double checked that I had the right configuration on my motors in the Naza setup utility, and that they were all spinning the proper direction.
Could this be a prop balance issue? or an engine issue? I just replaced one engine on the right side of my hexacopter, and it seems to always flip to the left.
Thanks!
EDIT:
seems like it will tip forward and backwards, too. I think it may depend on weather my craft is a little off level when I try to go airborne.
So here's what I'm running into, in GPS mode I can't the thing off of the ground pretty easy, but I do have a little bit of drift when hovering in GPS mode. But when I switch into manual mode, and give it throttle to lift off, it just flips over. I double checked that I had the right configuration on my motors in the Naza setup utility, and that they were all spinning the proper direction.
Could this be a prop balance issue? or an engine issue? I just replaced one engine on the right side of my hexacopter, and it seems to always flip to the left.
Thanks!
EDIT:
seems like it will tip forward and backwards, too. I think it may depend on weather my craft is a little off level when I try to go airborne.
Last edited: