• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

XA (3D) with Foam Board Design Challenge

Jonny Gum

Well-known member
#64
I flew the prototype quite a bit this weekend, but it's just so squirrely. Between the paper hinges, small wiggle in the control horns, the the not so rigid wing and tail, it kinda flies like crap, although its good for low and slow. It could do a wide no-name, but no pop tops as I couldnt get the vertical roll fast enough. Basically, I think everything need to be more rigid and less error in the control surfaces.
 
Last edited:

Ranger_107

Well-known member
#65
I flew the prototype quite a bit this weekend, but it's just so squirrely. Between the paper hinges, small wiggle in the control horns, the the not so rigid wing and tail, it kinda flies like crap, although its good for low and slow. It could do a wide no-name, but no pop tops as I couldnt get the vertical roll fast enough. Basically, I think everything need to be more rigid and less error in the control surfaces.
Nice. I have a crack yak design but no electronics yet cause I have other prioritys like quads and edfs lol. could be maidening it soon.
Can I participate in the challenge with mycrack yak? already have v1 plans
https://forum.flitetest.com/index.php?threads/foamboard-crak-yak.64650/#post-594422
 

Jonny Gum

Well-known member
#66