So, little story, my boos asked to me to try the 3d printed drone and crashed it in 40 seconds.
Unfortunately he managed to kill one arm and the antenna.
This is my drone killed in the office...
However in the meantime i bought an frsky trasmitter (qx7s) and an RX4R receiver.
But after binding , my controller ( SPF3 clone) does not read any kind of signal from the receiver.
( I used S-Bus and followed a video for the connection,
)
Can anyone help to resolve this problem?
This is the receiver Map
This is the photo that shows the connection that i've done
this is a close up on the connection on the receiver
....
at least i've time to redo the battery compartment...