Continuity Check on Naze32 rev5

[zakovich]

Hello,

i'm new to soldering and electronics in general so bare with me please.
After soldering my pins on the Naze32 the continuity Check Pings between -VBAT Pin and -TELEM Pin.
also I get a Ping between all my Motor GND Pins and same is the case with the Motor + Pins (the Signal Pins are not connected)

did I short anything ? when connecting my Board with the miniUSB it works fine and I can connect with CleanFlight App (all sensors looks good as well as the Calibarations).

Thank you

 

[ZoomNBoom]

There is no problem. Grounds (-) can be shared, and both the + and - on servo/esc connectors are always connected.

 

[zakovich]

There is no problem. Grounds (-) can be shared, and both the + and - on servo/esc connectors are always connected.

Thank you for the answer