esc

I've got a problem with my quadcopter. It's a 250, Power Pack E, Naze32 racing quad. I recently had to replace the FC, and once everything was back together, I plugged in the battery and tried to test it. Everything seemed to be working as normal, except that there wasn't even lift among the...

I know you hafto flash your ESCs with BLhelli to use oneshot but my question is Do the BLhelli ESCs sold by flite test hafto be flashed to use one shot or can I use oneshot without re flashing the ESCs Everywhere I look I cannot find anyone who talks about this. They are alwase flashing...

Hello there, This is my first quad build :o, and i'm having problems with the Emax simon k 12A esc. When i connect the esc to the battery, it does nothing but emit a starting sound, then stop and nothing else happens, even the sounds related to the configuration by transmitter, which happens...

So I ordered my Power Pack A tonight. My 3S 800 mah LiPo arrived. The urge hits. I pull a motor and esc from the junk bin. Solder it up. Plug it in (ch 1 just like on the video). Beep beep beep beep won't arm. Then it hits me in the video they always hook up Spektrum or Graupner (motor on...

Hi all, I'm very new to Quadcopters (RC in general), and I recently bought an electrohub frame along with its respective ready to fly quads electrohub electronics kit. I'm flying on a 3000 mah 4S nanotech battery. I'm not entirely sure if it's just me, because I have nothing to compare my drone...

I finally finished my ZMR250 build, but I've got a problem with it. It seemed to fly great at first until I started getting a little comfortable with it and I started getting more aggressive. I whipped it around 180 and pitched it at an aggressive angle and punched the throttle, then it tumbled...

Have you ever had a BLHeli ESC, ever had it on a craft and lost power in-flight? Last week I had that happen, the result was a hard impact crash, it did cause some damage; to my FT Explorer CORE but over all nothing I can't fix.. Had It been on my racer250 quad or one of my other craft, well...

Ive finished building my mini guinea with the corresponding power pack. I connected all of the servos correctly and connected the second motor to the AUX1 channel on my reliever(spektrum a610). I connect the battery and the esc connected to AUX1 beeps in a pattern like its going through its...

Hi Crew. I'm new to this game so take it easy. I have built, and rebuilt, flashed and reflashed, Quadtriple Checked my Motor/Prop directions, Calibrated, binded and everything that i can think of but: I can't get this quad to take off! Everything spins the right way and makes a great noise but...

Hey All! I'm new to this board and the hobby, but I've been learning quickly. I built the thrust meter that Josh shows in one of their videos and while running a 2200kv A2212-6 brushless with a 9x6 prop it just cuts out after 30 seconds. I still have to see if it will run longer or until a...

Hi guys. I'm quite new to the game and had a problem with my mini viggen that I Maidened last night. I'm running a 2200 3s and an eBay 4500 kv edf http://pages.ebay.com/link/?nav=item.view&alt=web&id=201269756781&globalID=EBAY-GB sorry I can't do the link thing on my phone The edf recommends...

Hi all ... first time poster, but long time flitetest show fan. So I've built my first quad, everything seems to have gone relatively smoothly, other than the fact that the motors don't spin when instructed (I know, that might be problematic) :) The quad I've put together uses an Seriously Pro...

I rescently just stated to get into RC flight. I built the FT storch with the following set up: Turnigy D2836/8 1100KV Brushless Outrunner Motor Turnigy 2200mAh 3S 20C Lipo Pack SF E-Prop 10x4.7 / 254x119.5mm w/ Adapters Black Turnigy TGY-i6 AFHDS Transmitter and 6CH Receiver (Mode 2) Hobbyking...

Hi all, First sorry if I am in the wrong forum. I'll admit it. I'm a noob. I have tried a few FT planes with no success. I tried designing my own plane... It was a flop. Now I am hoping that I can get some help as to which plane to attempt next. And if possible I would like to use some of my...

Hello There! This is my FIRST POST EVER and I am usually a secrete post reader and I am on this forum everyday. I am a test pilot and electrical system coordinator for diesel and turbine motor drones. I also fly rc planes and AP quads and a lot of FT planes. ANYWAY. I just came across a...

Recently I have been noticing slices in the heat shrink around my ESCs, and it's not just one ESC, all of them seem to have been hit in some way. My ZMR250 has the ESCs mounted on the arms which is great for active cooling, but puts them in danger of prop strikes. I figure the problem is that...

Sorry to be a bother, two areas I am confused on Electrohub Spider build with RTFQ kits: 1. Was I supposed to solder two of the motor leads flipped to get the twp that spin in the opposite direction, or is it based on the port the ESC's connect to? 2. Someplace, I thought in the FT Build video I...

Hey guys, I recently purchased an EMAX 12A ESC for my FT Mini Scout and can't get it working. I previously had a Turnigy plush 12A which worked just fine but I destroyed it one day by shorting it... The problem with the new ESC is that, when connecting the battery I don't get the usual series...

Just built my second FT plane, the Mustang. I love it. Thanks FT guys! I do want to get a bit more speed. Presently I'm running a Suppo 2217/7 1250KV, Suppo 30Amp esc and a 9 x 4.7 prop. I'm considering changing it to a Suppo 2217/6 1500KV (...

Im new to the hobby and am building a new plane, just a stock teksumo. I got a 30 amp plush esc, a neewer tx/rx a 2200 mah 3s lipo, 2 9g servos and am pondering a motor suitable for the setup considering the 30 amp esc. Any reccomendations? I also want some build tips regarding electronic...